Fuel Guage possible reverse wiring
Posted: Wed May 30, 2018 7:28 pm
Hi,
Recently had the engine out and attempted to adjust my fuel sender by +1/4 tank.
It had been reading about 5/8 when full. and zero'd out at about 3-4 gallons if I recall correctly.
Laid out an arch on the bench, and bent the arm about 25%.
Now it hangs up at way past full and does not budge. Drove it down to 1/4 tank and still hangs out up there.
Is it possible that I crossed the wires? Is that how it would behave with wires crossed?
If so, Could I cross the wires at the gauge to correct?
Working off of sender# 3. Boy do I hate this aftermarket crap!
Thanks
Joe
Recently had the engine out and attempted to adjust my fuel sender by +1/4 tank.
It had been reading about 5/8 when full. and zero'd out at about 3-4 gallons if I recall correctly.
Laid out an arch on the bench, and bent the arm about 25%.
Now it hangs up at way past full and does not budge. Drove it down to 1/4 tank and still hangs out up there.
Is it possible that I crossed the wires? Is that how it would behave with wires crossed?
If so, Could I cross the wires at the gauge to correct?
Working off of sender# 3. Boy do I hate this aftermarket crap!
Thanks
Joe