starter terminals
- dingo
- IAC Addict!
- Location: oregon - calif
- Status: Offline
starter terminals
How do i prevent the exposed starter motor terminals/connections from turning into a lump of rusty corrosion ?? blue rtv ? something else ??
'71 Kombi, 1600 dp
';78 Tranzporter 2L
" Fill what's empty, empty what's full, and scratch where it itches."
';78 Tranzporter 2L
" Fill what's empty, empty what's full, and scratch where it itches."
- Adventurewagen
- IAC Addict!
- Location: Seattle
- Status: Offline
Just take off the wires and wire brush the terminals nice and good. Clean the wire ends too and then just reassemble. Make sure it's nice and clean when it goes back together and your done.
The ends shouldn't turn into a rusty mess and if you brush the outside of the terminals off every few years it should be totally fine.
If you really want to cover it you could probably just find some rubber caps to pop onto them, but thats about all I can think of. nothing to really worry about, just clean it up real good once and then check your connections once every blue moon.
The ends shouldn't turn into a rusty mess and if you brush the outside of the terminals off every few years it should be totally fine.
If you really want to cover it you could probably just find some rubber caps to pop onto them, but thats about all I can think of. nothing to really worry about, just clean it up real good once and then check your connections once every blue moon.
63 Gulf Blue Notch
71 Sierra Yellow Adventurewagen
71 Sierra Yellow Adventurewagen
DjEep wrote:Velo? Are you being "over-run"? Do you need to swim through a sea of Mexican anchor-babies to get to your bus in the morning?
- Amskeptic
- IAC "Help Desk"
- Status: Offline