Clutch Arm Return Spring

Moderators: Sluggo, Amskeptic

Post Reply
User avatar
Hippie
IAC Addict!
Location: 41º 35' 27" N, 93º 37' 15" W
Status: Offline

Clutch Arm Return Spring

Post by Hippie » Fri Aug 27, 2010 2:03 pm

Anybody know how to put this thing on? My old one is shot.

Image

User avatar
midatlanticys
Addicted!
Location: Azores Portugal
Status: Offline

Post by midatlanticys » Fri Aug 27, 2010 3:10 pm

"The sad thing about governments is that in every single case, government formed by the people eventually becomes so large it begins to prey upon the people who created it.” -- B. Hoover

User avatar
Hippie
IAC Addict!
Location: 41º 35' 27" N, 93º 37' 15" W
Status: Offline

Post by Hippie » Fri Aug 27, 2010 4:22 pm

Did you ever know that you're my heeeero?

User avatar
Hippie
IAC Addict!
Location: 41º 35' 27" N, 93º 37' 15" W
Status: Offline

Post by Hippie » Sat Sep 04, 2010 5:27 pm

I got it. It wasn't that bad.
Hook the spring on the arm, put the arm on halfway, like in the link above. Pull the metal dust cover thing out to meet the arm so that the spring centers around it.
Push up the straight end of the spring with a wide, flat screwdriver until it hoks on the shelf cast onto the tranny housing. (Safety glasses on)
Then just shove the whole assembly the rest of the way onto the shaft--making sure to seat straight end of the spring the all the way onto the shelf.
Put on the C-clip. Put the clutch cable back inthe arm with the wingnut.
Done.

Post Reply