Lots of Engine Parts
Moderators: Sluggo, Amskeptic, bretski
- satchmo
- Old School!
- Location: Crosby, MN
- Status: Offline
Lots of Engine Parts
I have a ton of Type 4 engine parts. Some are rare, others not. All parts are pretty much geared to the 72-74 bus. Most are used unless noted. Here is a list with prices. Shipping is extra. I can send you a picture of anything you like as long as you contact me with your email address.
If stuff doesn't get much interest here I will post on theSamba in a few weeks.
So here goes:
Perfect cylinder cover tin pieces - (SOLD)
Alternator cover tin - $10
Alternator boot - Gone
Alternator AL75X - $25
Heat booster fan - (Sold)
Engine cooling fan - $25
Oil Cooler w/ mounting bracket - $10
Oil cooler seal (goes on tin to seal against oil cooler) - Gone
Oil filter mount - $5
Oil filler tube with extension and cap - $15
Oil filters (new in box Mahle brand) - Gone
Oil pressure switch boot (new) - Gone
Inspection plate - Sold
Oil drain plate with screen and plug - $5
Throttle bar cross shaft for 73-74 dual carb set-up - $15 (SOLD)
Brake booster rubber elbows - new (Original VW 021-129-637C) - Sold
Brake booster elbows (new Meyle brand 021-129-637F) - Sold
Charcoal canister (oval, flows nice) - (SOLD)
Rubber elbows for charcoal canister to fan 021-129 639 - Gone
Remanufactured distributor w/ points (211-905-205Q) - $55
Dual vacuum cans (tested and working) - Sold
Adjustable dual vacuum can (way cool) - $35
Lots of dual carb parts/jets/cut-offs etc (inquire)
Walker brand dual carb rebuild kits - new - (SOLD)
Dual carb manifolds with phenolic spacers and gaskets- $15 ea
Engine carrier bar - $5
Engine mounting bushings - Gone
1700-1800cc crank - $25
Crank main seals (Viton) - $5 ea
Con rods for 1700-1800 engine - $25 for a set of 4
Piston pin bushings for con rods (new) - Gone
Solid lifter push rods - $30 for set of 8
Rocker arms/shaft assemblies for 1700cc engine - Sold
Swivel foot adjusters (new "pinto style") 8mm - Sold
Spring/wire for keeping push rod tubes in place - $5 ea
1800cc piston and cylinder set (30K miles on them) - Sold
Valve covers with bales - $5 ea
Valve cover gaskets (quality cork gaskets) - Gone
VDO CHT sender wire - $10 (SOLD)
***Type 4 thermostat (tested) - $70 (SOLD)
***Mechanical fuel pump with phenolic spacer - Sold
Tim
If stuff doesn't get much interest here I will post on theSamba in a few weeks.
So here goes:
Perfect cylinder cover tin pieces - (SOLD)
Alternator cover tin - $10
Alternator boot - Gone
Alternator AL75X - $25
Heat booster fan - (Sold)
Engine cooling fan - $25
Oil Cooler w/ mounting bracket - $10
Oil cooler seal (goes on tin to seal against oil cooler) - Gone
Oil filter mount - $5
Oil filler tube with extension and cap - $15
Oil filters (new in box Mahle brand) - Gone
Oil pressure switch boot (new) - Gone
Inspection plate - Sold
Oil drain plate with screen and plug - $5
Throttle bar cross shaft for 73-74 dual carb set-up - $15 (SOLD)
Brake booster rubber elbows - new (Original VW 021-129-637C) - Sold
Brake booster elbows (new Meyle brand 021-129-637F) - Sold
Charcoal canister (oval, flows nice) - (SOLD)
Rubber elbows for charcoal canister to fan 021-129 639 - Gone
Remanufactured distributor w/ points (211-905-205Q) - $55
Dual vacuum cans (tested and working) - Sold
Adjustable dual vacuum can (way cool) - $35
Lots of dual carb parts/jets/cut-offs etc (inquire)
Walker brand dual carb rebuild kits - new - (SOLD)
Dual carb manifolds with phenolic spacers and gaskets- $15 ea
Engine carrier bar - $5
Engine mounting bushings - Gone
1700-1800cc crank - $25
Crank main seals (Viton) - $5 ea
Con rods for 1700-1800 engine - $25 for a set of 4
Piston pin bushings for con rods (new) - Gone
Solid lifter push rods - $30 for set of 8
Rocker arms/shaft assemblies for 1700cc engine - Sold
Swivel foot adjusters (new "pinto style") 8mm - Sold
Spring/wire for keeping push rod tubes in place - $5 ea
1800cc piston and cylinder set (30K miles on them) - Sold
Valve covers with bales - $5 ea
Valve cover gaskets (quality cork gaskets) - Gone
VDO CHT sender wire - $10 (SOLD)
***Type 4 thermostat (tested) - $70 (SOLD)
***Mechanical fuel pump with phenolic spacer - Sold
Tim
By three methods we may learn wisdom:
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius
- vistacruzer
- IAC Addict!
- Location: portland
- Status: Offline
hey
i need the linkage for the throttle to carbs for katherine's bus do you have a complete setup?
71 bench 1915
70 wide lowered body rag top 2056 type4 DTM nothing stock if I could touch it.
Growing old is mandatory. Growing up is optional.
70 wide lowered body rag top 2056 type4 DTM nothing stock if I could touch it.
Growing old is mandatory. Growing up is optional.
- satchmo
- Old School!
- Location: Crosby, MN
- Status: Offline
Re: hey
I have the crossbar for the 73-74 if that is what you need. PM me and I will send you a picture.71vistacruzer wrote:i need the linkage for the throttle to carbs for katherine's bus do you have a complete setup?
Tim
By three methods we may learn wisdom:
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius
- satchmo
- Old School!
- Location: Crosby, MN
- Status: Offline
I try not to get too attached to things. After all, I'm only visiting this planet. And I get around in a Vanagon, for now.chitwnvw wrote:This is kind of sad Tim. It's like your kids have moved out and you realize all the things that you will never have need of again. Vanagons and beyond for you?
Tim
By three methods we may learn wisdom:
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius
- vistacruzer
- IAC Addict!
- Location: portland
- Status: Offline
picture
Throttle bar cross shaft for 73-74 dual carb set-up with new end cup - $15
how about sending a picture buddy![pirate :pirate:](./images/smilies/icon_pirat.gif)
how about sending a picture buddy
![pirate :pirate:](./images/smilies/icon_pirat.gif)
71 bench 1915
70 wide lowered body rag top 2056 type4 DTM nothing stock if I could touch it.
Growing old is mandatory. Growing up is optional.
70 wide lowered body rag top 2056 type4 DTM nothing stock if I could touch it.
Growing old is mandatory. Growing up is optional.
- satchmo
- Old School!
- Location: Crosby, MN
- Status: Offline
Re: picture
I sent you some. Check yer email in-box. Check the spam box too in case it got caught in the filter.71vistacruzer wrote:Throttle bar cross shaft for 73-74 dual carb set-up with new end cup - $15
how about sending a picture buddy
Tim
By three methods we may learn wisdom:
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius
- Amskeptic
- IAC "Help Desk"
- Status: Offline
Re: Lots of Engine Parts
Still have these?satchmo wrote: (1 ea) Crank main seals (Viton) - $5 ea
(2) Spring/wire for keeping push rod tubes in place - $5 ea
Colin
- satchmo
- Old School!
- Location: Crosby, MN
- Status: Offline
Re: Lots of Engine Parts
Yup. I guess I can't guarantee the seals are Viton. They are the Victor Reinz and that off orange color. Check my ad on theSamba (http://www.thesamba.com/vw/classifieds/ ... ?id=896532)Amskeptic wrote:Still have these?satchmo wrote: (1 ea) Crank main seals (Viton) - $5 ea
(2) Spring/wire for keeping push rod tubes in place - $5 ea
Colin
Tim
By three methods we may learn wisdom:
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius
First, by reflection, which is noblest;
second, by immitation, which is easiest;
and third, by experience, which is bitterest. -Confucius