Page 1 of 1
Starter Testing
Posted: Tue Aug 02, 2011 11:48 am
by hambone
Hey, what is the method for checking a starter? It's been a long time. I seem to recall putting a screwdriver across the terminals, but I don't remember the exact method.
Want to isolate ignition switch VS the starter itself.
thanks!
Re: Starter Testing
Posted: Tue Aug 02, 2011 10:02 pm
by RSorak 71Westy
Yes simply connect the large terminal which is hot all the time to the small one and the starter should turn the engine.
Re: Starter Testing
Posted: Wed Aug 03, 2011 10:46 am
by hambone
Cool thanks.
Re: Starter Testing
Posted: Wed Aug 03, 2011 1:05 pm
by chitwnvw
Make sure it is in neutral.
Re: Starter Testing
Posted: Wed Aug 03, 2011 2:42 pm
by Amskeptic
RSorak 71Westy wrote:Yes simply connect the large terminal which is hot all the time to the small one and the starter should turn the engine.
And to keep electrical shenanigans away from the ignition switch, pull off the wire from the switch (red and black striped). If you are merely testing for function, keep the ignition off.
Colin
Re: Starter Testing
Posted: Wed Aug 03, 2011 3:10 pm
by hambone
Thank you thank you all good stuff.