Throw out bearing guide sleeve

Moderators: Sluggo, Amskeptic

Post Reply
User avatar
RZAR
Getting Hooked!
Location: San Diego, CA
Status: Offline

Throw out bearing guide sleeve

Post by RZAR » Tue Mar 31, 2009 3:17 pm

Is this metal guide sleeve for the throwout bearing http://www.airheadparts.com/viewDetail. ... oduct=7951
an acceptable replacement for the original plastic one on my 77 bus.
77 Bus. Stock 2.0 FI with Computronix ignitor and coil
Top
User avatar
Amskeptic
IAC "Help Desk"
IAC "Help Desk"
Status: Offline

Re: Throw out bearing guide sleeve

Post by Amskeptic » Tue Mar 31, 2009 8:33 pm

RZAR wrote:Is this metal guide sleeve for the throwout bearing http://www.airheadparts.com/viewDetail. ... oduct=7951
an acceptable replacement for the original plastic one on my 77 bus.
Sure. Lubrication (moly grease) between TO bearing and sleeve is mandatory with metal.
Colin
BobD - 78 Bus . . . 112,730 miles
Chloe - 70 bus . . . 217,593 miles
Naranja - 77 Westy . . . 142,970 miles
Pluck - 1973 Squareback . . . . . . 55,600 miles
Alexus - 91 Lexus LS400 . . . 96,675 miles
Top
User avatar
RZAR
Getting Hooked!
Location: San Diego, CA
Status: Offline

Post by RZAR » Tue Mar 31, 2009 8:50 pm

Thanks
77 Bus. Stock 2.0 FI with Computronix ignitor and coil
Top
Post Reply

Return to “Transaxle/CV/RWBearings”