Accelerator Cable

hambone · Post by **hambone** » Mon Feb 09, 2009 1:55 pm

Perhaps I'm being hasty, but I noticed last night (before I broke the trouble light bulb) that the cable, after coming out of the tube, seems to ride slightly on the upper transaxle case. Should I just bend the tube slightly to give the cable additional clearance?
It also may be a combination of encrusted dirt up there and the trans jacked slightly higher for engine removal.
I'll know more tonite after I get a new bulb.

Post by **Amskeptic** » Mon Feb 09, 2009 11:28 pm

hambone wrote:Perhaps I'm being hasty, but I noticed last night (before I broke the trouble light bulb) that the cable, after coming out of the tube, seems to ride slightly on the upper transaxle case. Should I just bend the tube slightly to give the cable additional clearance?
It also may be a combination of encrusted dirt up there and the trans jacked slightly higher for engine removal.
I'll know more tonite after I get a new bulb.

Yes, do what is necessary for a very happy accelerator cable.
Colin

hambone · Post by **hambone** » Tue Feb 10, 2009 8:51 am

Kinda a rudimentary question I know but I figured I'd ask before I go bendin' stuff.

chitwnvw · Post by **chitwnvw** » Tue Feb 10, 2009 10:21 am

hambone wrote:Kinda a rudimentary question I know but I figured I'd ask before I go bendin' stuff.

That's what I thought about taking apart my engine fan. Whoops! Guess I should have asked.

Post by **Amskeptic** » Tue Feb 10, 2009 11:03 am

Keep the questions coming. For every exchange here is read by hordes of lurkers that then pass the humility of seeking and the wisdom of replies along like ripples of knowledge through the space/time continuum.
What did you put in my coffee?
Colin

Itinerant Air-Cooled

Itinerant Air-Cooled

Accelerator Cable

Accelerator Cable

Re: Accelerator Cable