Accelerator Pedal Assembly Diagram
Posted: Thu Aug 10, 2006 9:46 am
My gas pedal broke off the floor pan a millenia ago and the PO used a door hinge bolted to the floor and pedal to "fix" the problem. I drove the bus over 3yrs before it finally blew up end of last year at which point driving with bare feet and using your toes to feather the pedal up and down was the only way to get from A to B :)
So I got this kit in from BusDepot
Its missing one of the c-clamp things, but I can deal.
The only problem is I have no stinking idea how to assemble the thing as I never had a legit pedal and underneath assembly in the first place. I've looked in Bentely, Muir, Haynes and two other odd ball books I have but could't find a pedal blow-out image in ANY of them. Some pieces I know go certain places so here is what I know, maybe somebody can look at theirs and explain or take a picture of theirs.
The pedal obviously sits in the new hinge I have and the new pin shown just to the pedals left is the axle for that piece. I use the c-clamps for either end to keep it on. Now on the underside of the pedal there is a hole where the long rod to the pedals right snaps into. Disc welded to that piece keeps the pedal from going too low and the boot slides over that.
What confuses me is how to orient the L shaped hinge. The small rod in the bottom left has a spring that slides onto it and a hole for the pin shown to go through it, but where does the cable attach, the pedal piece attach and the other rod attach. I seem to have 4 holes in the hinge (I'm guessing I only use 3) but I only have 2 rods to fill those holes? And how does the spring and short rod work under the bus?
So I got this kit in from BusDepot
Its missing one of the c-clamp things, but I can deal.
The only problem is I have no stinking idea how to assemble the thing as I never had a legit pedal and underneath assembly in the first place. I've looked in Bentely, Muir, Haynes and two other odd ball books I have but could't find a pedal blow-out image in ANY of them. Some pieces I know go certain places so here is what I know, maybe somebody can look at theirs and explain or take a picture of theirs.
The pedal obviously sits in the new hinge I have and the new pin shown just to the pedals left is the axle for that piece. I use the c-clamps for either end to keep it on. Now on the underside of the pedal there is a hole where the long rod to the pedals right snaps into. Disc welded to that piece keeps the pedal from going too low and the boot slides over that.
What confuses me is how to orient the L shaped hinge. The small rod in the bottom left has a spring that slides onto it and a hole for the pin shown to go through it, but where does the cable attach, the pedal piece attach and the other rod attach. I seem to have 4 holes in the hinge (I'm guessing I only use 3) but I only have 2 rods to fill those holes? And how does the spring and short rod work under the bus?